/usr/share/doc/wpa_supplicant/examples
Edit: /usr/share/doc/wpa_supplicant/examples/wps-ap-cli (1176B)
#!/bin/sh
CLI=wpa_cli
pbc()
{
echo "Starting PBC mode"
echo "Push button on the station within two minutes"
if ! $CLI wps_pbc | grep -q OK; then
echo "Failed to enable PBC mode"
fi
}
enter_pin()
{
echo "Enter a PIN from a station to be enrolled to the network."
printf "Enrollee PIN: "
read pin
cpin=`$CLI wps_check_pin "$pin" | tail -1`
if [ "$cpin" = "FAIL-CHECKSUM" ]; then
echo "Checksum digit is not valid"
printf "Do you want to use this PIN (y/n)? "
read resp
case "$resp" in
y*)
cpin=`echo "$pin" | sed "s/[^1234567890]//g"`
;;
*)
return 1
;;
esac
fi
if [ "$cpin" = "FAIL" ]; then
echo "Invalid PIN: $pin"
return 1
fi
echo "Enabling Enrollee PIN: $cpin"
$CLI wps_pin any "$cpin"
}
show_config()
{
$CLI status wps
}
main_menu()
{
echo "WPS AP"
echo "------"
echo "1: Push button (activate PBC)"
echo "2: Enter Enrollee PIN"
echo "3: Show current configuration"
echo "0: Exit wps-ap-cli"
printf "Command: "
read cmd
case "$cmd" in
1)
pbc
;;
2)
enter_pin
;;
3)
show_config
;;
0)
exit 0
;;
*)
echo "Unknown command: $cmd"
;;
esac
echo
main_menu
}
main_menu